ltwguns.com

Actions Speak Louder Than Words
It is currently Thu Feb 29, 2024 2:31 pm

All times are UTC-08:00




Post new topic  Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Wed May 24, 2023 10:54 am 
Offline
Senior Member

Joined: Mon Jun 27, 2005 12:15 am
Posts: 435
I just put a C&S extended safety in a C-series P-35. You can just barely discern a click into the hole when switching safety on and off and the safety is mushy and difficult to move. I already have a blister forming, hah, been shooting Glocks too much and my thumb has forgotten the joy of a good thumb safety.

So, do I modify the frame detent holes or modify the detent... or both... how?

Thanks!

_________________
God Bless
45Fundi


Top
   
PostPosted: Wed May 24, 2023 8:30 pm 
Offline
Board Member
Board Member

Joined: Fri Feb 20, 2004 5:30 pm
Posts: 4311
Location: MI
Check this thread, there might be a few bits that will help. But also, I have taken the extractor spring buffer for an AR15 and added it to the BHP safety detent spring and had good results. I've modified the detent end shape. I've never modified the dimples in the frame but I sure would if I had to!

https://forum.ltwguns.com/viewtopic.php?f=6&t=9862


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 2 posts ] 

All times are UTC-08:00


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited