ltwguns.com

Actions Speak Louder Than Words
It is currently Sat Mar 07, 2026 6:50 am

» » »

All times are UTC-08:00



Post new topic  Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Previous topic | Next topic 
Author Message
OldLawman
 Post subject: Kimber Slide Question
PostPosted: Sun Apr 03, 2005 6:50 am 
Offline
Senior Member

Joined: Mon Apr 26, 2004 5:44 pm
Posts: 414
Location: Maryland
Is there enough metal to thin down the front of a Kimber slide al la a High Power to remove the front serrations ? I have seen pics of C.T. Brian's excellent work on Colts like this.

Got a new project in mind on a NIB stainless Series I Kimber. :wink:
Top
   
Reply with quote  
Steve Bailey
 Post subject:
PostPosted: Sun Apr 03, 2005 8:14 am 
Offline
Administrator
Administrator

Joined: Mon Feb 16, 2004 3:47 pm
Posts: 1812
Location: Tempe, Arizona
From my perspective yes, there is enough material there to do a Browning HP cut on a Kimber slide. I have seen them done by hand, and it can leave a little to be desired. But if they were machined off I think it would be fine.

Let us know how it comes out.

_________________
Heirloom Precision, LLC.
480-804-1911

"If everyone is thinking alike, someone isn't thinking."
- General George Patton Jr
Top
   
Reply with quote  
Display posts from previous:  Sort by  
Post new topic  Reply to topic  Page 1 of 1
  [ 2 posts ] 

» » »

All times are UTC-08:00

Who is online

Users browsing this forum: No registered users and 28 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
Powered by phpBB® Forum Software © phpBB Limited